Power Transmission Equipment, Conveyor Belt and Auto Gate Systems. 工业传动件,输送带,遥控门系统。
Through redesigning the structure of the original PFD circuit and based on the traditional D trigger PFD, two new PFDs, transmission gate D trigger PFD and flip-latch based PFD were proposed. 通过对原有PFD电路结构进行重新设计,在传统D触发器PFD的基础上提出了两种新型PFD:传输门D触发器型PFD和基于锁存器的PFD。
Based on the working principle, counter structure and Clocked Transmission Gate Adiabatic Logic circuits, a design scheme of decimal counter with reset is proposed. 通过对计数器和钟控传输门绝热逻辑电路工作原理及结构的研究,提出一种带复位功能的低功耗十进制计数器设计方案。
Measuring average transmission time of gate circuit with an ordinary oscilloscope 用普通示波器测门电路平均传输时间
Observing transmission characteristic curve of gate circuit with computer 门电路传输特性曲线的计算机辅助观测
The multi-stage transmission time is obtained by connecting several gate circuits in series, then divided by stage number, the single gate average transmission time is derived. 将多个门电路串联,测出多级传输时间,除以级数,可得单个门电路的平均传输时间。
To Ameliorate Scanning Admeasuring Voltage Transmission Characteristic of TTL NAND Gate TTL与非门电压传输特性实验的改进
Design Estimation on the Transmission Consumption of Light Power and Efficiency of the Coupling in Gate Striking System of Light Fired Thyristors 光触发晶闸管门极触发系统中光功率的传输损耗与耦合效率的设计估算
Transmission gate circuit used in 4-2 adders greatly reduced transistor quantity while increased system speeds in the meantime. 4-2加法器采用传输门电路实现,大大减少了所需晶体管的数目,同时提高了系统速度。
The Door Application of CMOS Transmission Gate CMOS传输门的应用
On the basis of above principle, the cross-coupled dynamic adiabatic memorial units and adiabatic flip-flops are designed by single channel and double channel transmission gate. 在此基础上设计单沟道和双沟道传输门动态绝热锁存器,使其保存信息时,存储介质与外界隔离。
Application and research of multi& valued logics in transmission gate combination 多值逻辑在传输门组合中的应用研究
Then this principle is adopted in ternary circuit, a new ternary D type edge-triggered flip-fiop based on CMOS transmission gate is proposed. 在二值单闩锁结构边沿触发器的基础上,把利用时钟信号竞争冒险的思想应用于三值电路中,提出了基于CMOS传输门的二值D型时钟信号竞争型边沿触发器。
A Type of Low Power Adiabatic Logic Circuit with Cross-coupled Transmission Gate 一种交叉耦合低功耗传输门绝热逻辑电路
A new adiabatic logic circuit adopting two-phase non-overlap power clocks-Clocked Transmission Gate Adiabatic Logic circuit was designed by using the bootstrap effect of NMOS transistors, so that it could charge or discharge output loads in a fully adiabatic manner. 本文利用NMOS管的自举效应设计了一种新的采用二相无交叠功率时钟的绝热逻辑电路&钟控传输门绝热逻辑电路,实现对输出负载全绝热方式充放电。
This paper discusses the principle of relative adiabatic computing of single channel transmission gate from the idea of finite dynamic power dissipation. 该文从动态功耗在工程上有界限的观点出发,讨论单沟道传输门的相对绝热计算原理。
Discussion on Combined Construction of Gas Transmission Substation and Gate Station for Gas Transmission Pipeline 长输管道分输站与门站合建的探讨
Level restoration pass-transistor logic is proposed for low speed cell while dynamic transmission gate logic for high speed cell. 低速单元采用带有电平恢复的传输管逻辑实现,高速单元采用动态传输门逻辑实现。
The combined construction of gas transmission substation and city gate station for gas transmission pipeline has obvious superiority, but it can not be spread for different reasons. 长输管道气体分输站和城市门站二站合一建设具有非常明显的优越性,但由于种种原因未能推广。
Taking the combined construction of Luoyang gas transmission substation and city gate station for example, the feasibility of the combined construction of two stations is analyzed technically. 以洛阳分输站和门站的合建为例,对二站合一建设在技术方面进行了可行性分析。
Design of Clocked Transmission Gate Adiabatic Logic Circuit and SRAM 钟控传输门绝热逻辑电路和SRAM的设计
After use the most simplified algorithm, we can use current-mode logic or transmission gate logic to reduce the delay time, or use pipe-line decoding approach to reduce the constraint of delay time. 在采用最简化的算法之后,可以采用电流模逻辑或者传输门逻辑来减小延迟,或者采用流水线解码的方式将延迟要求降低。